Inert Impulsive Expendable Acoustic Source (IIEAS)

Navy STTR 24.A - Topic N24A-T018
ONR - Office of Naval Research
Pre-release 11/29/23   Opens to accept proposals 1/03/24   Now Closes 2/21/24 12:00pm ET    [ View Q&A ]

N24A-T018 TITLE: Inert Impulsive Expendable Acoustic Source (IIEAS)


OBJECTIVE: Develop an expendable impulsive underwater sound source without explosives or combustible gas packaged in A-size sonobuoy and/or Signal, Underwater Sound (SUS) form factor.

DESCRIPTION: High-energy impulsive underwater acoustic sources such as air-guns, sparkers, or explosive/implosive charges are used for oil and gas exploration, seabed characterization, and underwater target detection. Explosive charges, such as the SUS source, are especially convenient for being compact and mobile for easy deployment by surface or airborne platforms. SUS is routinely used to conduct transmission loss experiments used to determine bottom loss parameters which are used in databases for seabed bottom properties. A typical SUS charge contains the chemical compound trinitrotoluene, TNT; a chemical compound used as an explosive material requiring special handling. However, it’s been shown that impulsive sound sources, such as created by the implosion of lightbulbs, can be useful for transmission loss or seabed characterization experiments. This STTR topic seeks development of an impulsive sound source without explosives or combustible gas packaged in A-size sonobuoy and/or SUS form factor.

PHASE I: Develop an impulsive underwater acoustic source concept that does not explosives or combustible gas. The source shall exhibit a Peak Source Level greater than or equal to 190 dB//1µPa@1m at water depths of 10 – 200 m or deeper. Energy Spectral Density should be within +/- 10 dB re 1muPa^2 s/Hz @ 1 m from 30 Hz to greater than or equal to 20 kHz. The concept should describe the mechanistic underpinnings of the source and support it with models and simulations. Simulations should demonstrate the source level and spectral content for as a function of depth in a representative ocean environment.

PHASE II: Develop, build, and demonstrate a hardware version of the source concept resulting from Phase I. The demonstration source does not have to be expendable, but should demonstrate the capabilities for source level and spectral characteristics stated in the requirements. Demonstrate that the impulsive source signature is repeatable and predictable for a given source depth. Develop a capability for triggering the source at a specific depth over the range specified. Develop a plan in consultation with the Navy for demonstrating the source to include compliance with environmental regulations. After demonstrations, develop a design for an expendable version of the source with form factors compatible with A-size sonobuoy and SUS.

PHASE III DUAL USE APPLICATIONS: The expected transition will be an inert impulsive expendable underwater acoustic source that can be used for transmission loss surveys, geotechnical surveys, and other naval or civil applications. The inert nature of the source will make handling much safer than currently used sources. Phase III tasking shall include refining the prototype design and fabrication of a near-final product suitable for testing. Sufficient test articles should be manufactured to establish repeatability of the specified source characteristics. An at-sea experimental test and evaluation plan shall be developed and executed in consultation with the sponsor. Test articles meeting the SUS form factor can be demonstrated by being deployed by hand or with the use of a suitable launcher from the deck of a ship. Test articles meeting the A-size sonobuoy form factor must demonstrate compatibility with standard launch tubes with a test plan developed in consultation with the platform operator. In their final forms, the SUS form factor is expected to be used for operational surveys or in support of basic and applied research. The A-size sonobuoy form factor can be dropped from helicopters for ASW search and or environmental characterization.


  1. Heard, Garry J.; McDonald, M.; Chapman, N.R. and Jashke, L. "Underwater Light Bulb Implosions – A useful acoustic source." Oceans '97. MTS/IEEE Conference Proceedings Page(s), Vol.2, 1997, pp. 755-762. DOI: 10.1109/OCEANS.1997
  2. Chapman, N.R. "Source levels of shallow explosive charges." J. Acoust. Soc. Am., 84(2),1988, pp. 697-702
  3. McNeese, A.R.; Lee, K.M.;, Sagers, J.D.;, Lee, M.J. and Wilson, P.S. "Experimental observations of a rupture induced underwater sound source." J. Acoust. Soc. Am. 148(4), 2020, pp. EL370–EL374.

KEYWORDS: Underwater Acoustics; Sound Propagation; Sound Source; Geoacoustic Inversion; Bubble pulse; Implosion


The Navy Topic above is an "unofficial" copy from the Navy Topics in the DoD 24.A STTR BAA. Please see the official DoD Topic website at for any updates.

The DoD issued its Navy 24.A STTR Topics pre-release on November 28, 2023 which opens to receive proposals on January 3, 2024, and now closes February 21, (12:00pm ET).

Direct Contact with Topic Authors: During the pre-release period (November 28, 2023 through January 2, 2024) proposing firms have an opportunity to directly contact the Technical Point of Contact (TPOC) to ask technical questions about the specific BAA topic. Once DoD begins accepting proposals on January 3, 2024 no further direct contact between proposers and topic authors is allowed unless the Topic Author is responding to a question submitted during the Pre-release period.

SITIS Q&A System: After the pre-release period, until January 24, 2023, at 12:00 PM ET, proposers may submit written questions through SITIS (SBIR/STTR Interactive Topic Information System) at by logging in and following instructions. In SITIS, the questioner and respondent remain anonymous but all questions and answers are posted for general viewing.

Topics Search Engine: Visit the DoD Topic Search Tool at to find topics by keyword across all DoD Components participating in this BAA.

Help: If you have general questions about the DoD SBIR program, please contact the DoD SBIR Help Desk via email at

Topic Q & A

1/12/24  Q. Would it be possible to provide a few more thoughts concerning the Navy’s thinking? A “CONOPS” places constraints not only on the design of the device but also on the concept of the source of the impulsive signal.
  • Is the intent of this topic to provide an acoustic source that can immediately, upon deployment, transmit an acoustic impulse, or can the source be deployed at some time (TBD) prior to when the signal is needed, and thus initiated via some command reception capability.
  •    A. The source should NOT immediately, upon deployment, transmit an acoustic impulse. We are most interested in controlling for the depth at which the impulse occurs. Current operational use is that the source transmits after deployment and upon reaching a prescribed depth as it descends, typically 60 – 1000 ft. The depth is pre-determined and ideally can be programmed for any depth over the range.

    [ Return ]